BenQ W1070+W Instrukcja Użytkownika Pobierz pdf (Strona 22)

Operation

4. If you are prompted to enter the password, use the arrow keys on the projector or remote control

to enter a six-digit password. See Utilizing the password function for details.

5. Switch on the connected equipment.

6. The projector starts to search for available input signals. The current input signal being scanned

displays on the screen. If the projector doesn't detect a valid signal, the "No Signal" message

appears. You may press SOURCE on the projector or remote control to select your desired input

signal.

7. If the horizontal frequency of the input source exceeds the range of the projector, the "No Signal"

message displays on the screen. It will remain on-screen until you change the input source to an

appropriate one.

Shutting down the projector

1. Press on the projector or on the remote control. The projector displays a shutdown

confirmation message.

2. Press or a second time.

The POWER indicator light

flashes orange and the fans run for about two minutes to cool the

lamp. The projector doesn’t not respond to any commands during

the cooling process.

3. When the cooling process ends, a "Power Off Ring Tone" will

be heard, and the POWER indicator light will show a solid

orange.

To turn off the ring tone, see Power On/Off Ring Tone for details.

If the projector will not be used for an extended period, unplug the power cable from the power

outlet.

Avoid turning on the projector immediately after turning it off as excessive heat may shorten lamp life.

The actual lamp life may vary due to different environmental conditions and usage.

Step 3:

Specify 2D Keystone.

Step 4:

Specify Auto Source.

Now you’ve completed the initial setup.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 62 63

Brak uwag

BenQ W1070+W Instrukcja Użytkownika Strona 22